PT-FZ570U 3LCD Fixed Installation Projector

 

PT-FZ570

Product details

Price priority and easy installation LCD projector Designed to easily replace current projection installation in education and corporate environments

Key features
  • LCD, 4500 lumens, WUXGA
  • Long lamp replacement cycle of 8,000 hours and filter replacement cycle of 16,000 hours.
  • Dust resistant design for lasting brightness
  • 1.8x zoom lens and wide horizontal and vertical lens shift for flexible installation
  • 10,000:1 contrast ratio
  • Thumbnail
  • Thumbnail
Power supply AC100 - 240V 4.7 - 1.9A 50Hz/60Hz
Power consumption 413W
Power consumption | Standby Mode (Eco) 0.5W, 0.3W (Taiwan)
Power consumption | Standby Mode (Normal) 12W
Power consumption | Standby Mode (Normal and Audio monitor out) 30W
BTU value Max 1,410 BTU
LCD panel | Panel size 16.3 mm (0.64 in) diagonal (16:10 aspect ratio)
LCD panel | Display method Transparent LCD panel (x 3, R/G/B)
LCD panel | Drive method Active matrix
LCD panel | Pixels 2,304,000 (1,920 x 1,200) x 3, total of 6,912,000 pixels
LENS Manual zoom (throw ratio 1.22-2.26:1),
Manual focus, F 1.6-2.2, f 17.1-31.7 mm
Lamp 270 W UHM lamp
Lamp replacement cycle
6,000 hours (lamp power: Normal), 8,000 hours (lamp power: Eco)
This is the maximum value when the lamp is turned on for 2 hours
and off for 0.25 hours.
Screen size 1.02- 7.62 m (40-300 inches) (16:10 aspect ratio)
Brightness 4,500 lumens
(Lamp power: Normal, Dynamic mode, Iris off, Daylight View:off, Auto Power Save:off)
Center-to-corner uniformity 90%
Contrast 10,000:1
(Lamp power: Normal, Dynamic mode, Iris on, Daylight View:off, Auto Power Save:off)
Resolution 1,920 x 1,200 pixels
Scanning frequency | HDMI/DIGITAL LINK fH: 15- 91kHz, fV: 24 - 100Hz, dot clock: 25 - 162 MHz
Scanning frequency | RGB fH: 15- 91kHz, fV: 24 - 100Hz, dot clock: 162 MHz or lower
Scanning frequency | YPBPR (YCBCR) 525i (480i): fH15.73 kHz; fV59.94 Hz,
625i (576i): fH15.63 kHz; fV50 Hz,
525p (480p): fH31.47 kHz; fV60 Hz,
625p (576p): fH31.25 kHz; fV50 Hz,
750 (720)/60p: fH45.00 kHz; fV60 Hz,
750 (720)/50p: fH37.50 kHz; fV50 Hz,
1125 (1080)/60i: fH33.75 kHz; fV60 Hz,
1125 (1080)/50i: fH28.13 kHz; fV50 Hz,
1125 (1080)/25p: fH28.13 kHz; fV25 Hz,
1125 (1080)/24p: fH27.00 kHz; fV24 Hz,
1125 (1080)/24sF: fH27.00 kHz; fV48 Hz,
1125 (1080)/30p: fH33.75 kHz; fV30 Hz,
1125 (1080)/60p: fH67.50 kHz; fV60 Hz,
1125 (1080)/50p: fH56.25 kHz; fV50 Hz
Scanning frequency | Video/S-Video fH: 15.75 kHz, fV: 59.94 Hz [NTSC/NTSC4.43/PAL-M/PAL60]
fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]
Keystone correction range Vertical ±25°, horizontal ±30°
Optical axis shift Vertical: ±60% (Manual) Horizontal: ±30% (Manual)
Installation Ceiling/floor, front/rear
Speaker 4.0 cm (1-9/16 in) 10W (monaural) x 1
Terminals | HDMI In 1/HDMI In 2 | HDMI 19-Pin x2 Deep Color, compatible with HDCP,
Audio signal: linear PCM
(sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)
Terminals | COMPUTER 1 IN D-sub HD 15-pin (female) x 1
Terminals | COMPUTER 1 IN | R, G, B 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G)
HD/VD, SYNC: TTL, high impedance, positive/negative
automatic
Terminals | Computer 1 IN | Y, PB, PR (Y, CB, CR) Y: 1.0 Vp-p (including sync signal),
PBPR(CBCR): 0.7 Vp-p, 75 ohms
Terminals | Computer 1 IN | Y/C Y: 1.0 Vp-p (including sync signal), C: 0.286 Vp-p, 75 ohms
Terminals | Computer 2 IN/1 OUT D-sub HD 15-pin (female) x 1
Terminals | Computer 2 In/1 Out | R, G, B 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G)
HD/VD, SYNC: TTL, high impedance, positive/negative
automatic
NOTE: SYNC/HD and VD terminals do not accept tri-level sync signals.
Terminals | Computer 2 IN/1 OUT | Y, PB, PR (Y, CB, CR) Y:1.0 Vp-p (including sync signal),
P BPR(CBCR): 0.7 Vp-p, 75 ohms
Terminals | VIDEO IN Pin jack x 1, 1.0 Vp-p, 75 ohms
Terminals | AUDIO IN 1/AUDIO IN 2 M3 x 2, 0.5 Vrms, input impedance: 22 kilohms or more
Terminals | AUDIO IN 3 Pin jack(L, R) x 1, 0.5 Vrms, input impedance: 22 kilohms or more
Terminals | VARIABLE AUDIO OUT M3 x 1 (monitor out, stereo)
0-2.0 Vrms, variable, output impedance: 2.2 kilohms or less
Terminals | SERIAL IN D-sub 9 p x 1, for external control (RS-232C compliant)
Terminals | DIGITAL LINK/LAN RJ-45 x 1 (HDBaseT™ compatible), 100Base-TX, PJLink™(Class 1),
Deep Color, compatible with HDCP
A udio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)
Terminals | LAN RJ-45 x 1 for network connection 10Base-T/100Base-TX,
compatible with Art-Net, PJLink™(Class 1)
Terminals | WIRELESS USB Type A x 1, for wireless projection with optional dongle (ET-WML100)
Terminals | DC OUT USB Type A x 1, for power supply (DC5 V, max 900 mA)
Power cord length 2.0 m (6 ft7 in)
Cabinet materials Molded plastic
Dimensions (W x H x D) 498 x 145*3 x 398.3mm
(19-19/32 x 5-11/16*3 x 15-11/16 in ) with supplied lens
Weight Approx. 7.9kg (17.4lbs)
Operating noise 29 dB (Eco), 33 dB (Normal)
Operating environment | Operating temperature 0-40 °C (32-104 °F)
Operating environment | Operating humidity 20%-80% (no condensatio
Technology LCD
<sup>(1)</sup> Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.<br/>
<sup>(2)</sup> Measured at center area of projector screen. Measurement method is in compliance with ISO/IEC 21118: 2012. Value is average of all products when shipped. May differ depending on actual unit.